Horstmann HRT4-ZW Guia do Utilizador descarregar pdf (Página 8)

Fitting the HRT4-ZW Room Thermostat

Before final installation it is advisable to commission the product and ensure that the Thermostat

and Receiver are communicating satisfactorily. First install the 2 x type AAA batteries provided

making sure that they are fitted correctly as indicated by the markings in the battery compartment.

Once the thermostat and receiver are successfully ‘paired’ the thermostat can be installed in its

correct location. Please see Z-Wave pairing instructions on page 10.

Avoid installing the thermostat against or behind any large metal surfaces which could interfere

with the radio signals to and from the ASR-ZW receiver. The HRT4-ZW should be mounted on an

internal wall approximately 1.5 metres from floor level using the wall plate provided and should be

in a position away from draughts, direct heat and sunlight. Ensure that there will be enough space

to allow easy access to the two retaining screws located at

the base of the wall plate.

Before fixing the wall plate in position check to see that

the thermostat and Receiver are still able to communicate

satisfactorily by turning the thermostat temperature up and

down to switch the ASR–ZW receiver on and off.

Offer the plate to the wall in the position where the ASR-ZW

is to be mounted and mark the fixing positions through the

slots in the wall plate. Drill and plug the wall, then

secure the plate into position. The slots in the wall

plate will compensate for any misalignment of the

fixings.

Complete the installation by swinging the room

thermostat into position by engaging with the lugs at

the top of the wall plate before pushing it carefully

home into its plug-in terminal block.

Tighten the 2 captive screws on the underside of the

unit.

Now ensure that the heating system is responding to

the ON/OFF commands from the Room Thermostat

and explain its operation to the householder before

handing over these User Instructions

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

Horstmann HRT4-ZW Guia do Utilizador Página 8